期刊检索

  • 2026年第34卷
  • 2025年第33卷
  • 2024年第32卷
  • 2023年第31卷
  • 2022年第30卷
  • 2021年第29卷
  • 2020年第28卷
  • 2019年第27卷
  • 2018年第26卷
  • 2017年第25卷
  • 2016年第24卷
  • 2015年第23卷
  • 2014年第22卷
  • 2013年第21卷
  • 2012年第20卷
  • 2011年第19卷
  • 2010年第18卷
  • 第1期
  • 第2期

主管单位 中华人民共和国
工业和信息化部
主办单位 中国材料研究学会
哈尔滨工业大学
主编 苑世剑 国际刊号ISSN 1005-0299 国内刊号CN 23-1345/TB

期刊网站二维码
微信公众号二维码
引用本文:冷美杰,肖一凡,张亚楠,张阳,陈善永,刘庆生.循环加卸载下铝电解阴极炭块的声发射特征研究[J].材料科学与工艺,2026,34(4):85-96.DOI:10.11951/j.issn.1005-0299.20250044.
LENG Meijie,XIAO Yifan,ZHANG Yanan,ZHANG Yang,CHEN Shanyong,LIU Qingsheng.Study on the acoustic emission characteristics of aluminum electrolysis cathode carbon blocks under cyclic loading and unloading[J].Materials Science and Technology,2026,34(4):85-96.DOI:10.11951/j.issn.1005-0299.20250044.
【打印本页】   【HTML】   【下载PDF全文】   【查看/发表评论】  【下载PDF阅读器】  【关闭】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 631次   下载 56次 本文二维码信息
码上扫一扫!
循环加卸载下铝电解阴极炭块的声发射特征研究
冷美杰1,肖一凡1,张亚楠2,张阳3,陈善永4,刘庆生1
(1.江西理工大学 冶金工程学院,江西 赣州 341000; 2.中铝郑州有色金属研究院有限公司,郑州 450000;3.中国铝业股份有限公司连城分公司,兰州 730000; 4.包头铝业有限公司,内蒙古 包头 014000 )
摘要:
本文对铝电解槽常用的两种阴极炭块材料石墨质炭块和石墨化炭块进行循环加卸载实验,采用损伤力学、能量和声发射频谱分析的手段分析反复应力作用下阴极炭块材料的破裂机理和损伤演化。结果表明,应力增大时,低应力水平下应力对炭块主要起强化作用,炭块内部孔隙被压实;高应力水平下应力对炭块主要起损伤作用,炭块内部微裂纹逐渐增多并扩展,炭块受损越来越严重,损伤不可逆程度越来越大,直至炭块彻底破裂失去承载能力,应力减小时会引起炭块内部部分损伤的修复。炭块的彻底破坏主要与低频高振幅信号和中频高振幅信号的出现有关,炭块彻底破坏有两种情况:低频高振幅信号连续出现,大尺度裂纹的形成导致炭块彻底破坏;多个中频高振幅信号与低频信号同时出现,中尺度裂纹扩展贯穿炭块导致炭块彻底破坏。
关键词:  循环加卸载  铝电解  阴极炭块  力学  能量  声发射
DOI:10.11951/j.issn.1005-0299.20250044
分类号:TG115.28,TH145.1+3
基金项目:国家自然科学基金资助项目(52274350).
Study on the acoustic emission characteristics of aluminum electrolysis cathode carbon blocks under cyclic loading and unloading
LENG Meijie1, XIAO Yifan1, ZHANG Yanan2, ZHANG Yang3, CHEN Shanyong4, LIU Qingsheng1
(1.School of Metallurgical Engineering, Jiangxi University of Science and Technology, Ganzhou 341000, China; 2.Chalco Zhengzhou Research Institute Co., Ltd., Zhengzhou 450000, China; 3. Chalco Liancheng Branch, Lanzhou 730000, China; 4.Baotou Aluminum Co., Ltd., Baotou 014000, China)
Abstract:
In this paper, cyclic loading and unloading tests were carried out on two kinds of cathode carbon block materials commonly used in aluminum electrolytic cells, graphite carbon block and graphitized carbon block. The fracture mechanism and damage evolution of cathode carbon block materials under repeated stress were analyzed by damage mechanics, energy, and acoustic emission spectrum analysis. The results indicate that as stress increases, stress mainly reinforces the carbon blocks at low stress levels, the internal pores were compacted. At high stress levels, stress primarily causes damage, with microcracks gradually increasing and propagating within the blocks, leading to increasingly severe damage and irreversible deterioration until the blocks completely fractured and lost the load-bearing capacity. When stress decreases, it can cause partial repair of internal damage in the carbon blocks. The complete failure of carbon blocks is primarily associated with the occurrence of low-frequency high-amplitude signals and medium-frequency high-amplitude signals. There are two scenarios leading to the complete failure of carbon blocks: continuous appearance of low-frequency high-amplitude signals,result in the formation of large-scale cracks, which ultimately cause the failure; and the simultaneous occurrence of multiple medium-frequency high-amplitude signals alongside low-frequency signals lead to the propagation and penetration of medium-scale cracks throughout the carbon block, thereby causing the complete failure.
Key words:  cyclic loading and unloading  aluminum electrolysis  cathode carbon block  mechanics  energy  acoustic emission

友情链接LINKS