期刊检索

  • 2026年第58卷
  • 2025年第57卷
  • 2024年第56卷
  • 2023年第55卷
  • 2022年第54卷
  • 2021年第53卷
  • 2020年第52卷
  • 2019年第51卷
  • 2018年第50卷
  • 2017年第49卷
  • 2016年第48卷
  • 2015年第47卷
  • 2014年第46卷
  • 2013年第45卷
  • 2012年第44卷
  • 2011年第43卷
  • 2010年第42卷
  • 第1期
  • 第2期

主管单位 中华人民共和国工业和信息化部 主办单位 哈尔滨工业大学 主编 李隆球 国际刊号ISSN 0367-6234 国内刊号CN 23-1235/T

期刊网站二维码
微信公众号二维码
引用本文:姜旭,齐昊,强旭红,孙凯.湿热老化对FRP-钢胶接节点力学性能的影响[J].哈尔滨工业大学学报,2024,56(11):26.DOI:10.11918/202304069
JIANG Xu,QI Hao,QIANG Xuhong,SUN Kai.Mechanical behavior of FRP-steel adhesively-bonded joints under hygrothermal ageing[J].Journal of Harbin Institute of Technology,2024,56(11):26.DOI:10.11918/202304069
【打印本页】   【HTML】   【下载PDF全文】   【查看/发表评论】  【下载PDF阅读器】  【关闭】
过刊浏览    高级检索
本文已被:浏览 591次   下载 431次 本文二维码信息
码上扫一扫!
分享到: 微信 更多
湿热老化对FRP-钢胶接节点力学性能的影响
姜旭,齐昊,强旭红,孙凯
同济大学 土木工程学院,上海 200092
摘要:
为进一步研究湿热老化对纤维增强复合材料(FRP)-钢胶接节点力学性能的影响,在现有试验的基础上,采用轮盘加载装置,分别从6个加载条件对湿热老化处理后的FRP-钢胶接节点进行一系列加载测试,研究了湿热老化对FRP-钢胶接节点的极限破坏荷载、破坏模式、刚度以及强度破坏准则的影响,并将结果与未老化胶接节点进行比较。试验结果表明:在剪切和拉伸荷载作用下,湿热老化显著降低了FRP-钢胶接节点的极限破坏荷载,分别降至11.0 kN和41.9 kN;在组合荷载作用下,湿热老化对极限破坏荷载的影响较小;老化与未老化FRP-钢胶接节点的强度破坏准则曲线彼此接近;对于拉伸和拉伸/剪切组合荷载条件,湿热老化改变了FRP-钢胶接节点的破坏模式,即从FRP夹芯板和结构胶粘贴层之间的部分界面破坏到覆盖整个结构胶粘结区域的FRP分层破坏和纤维断裂破坏的组合; 在6个加载条件下,湿热老化均明显降低了FRP-钢胶接节点的刚度。因此,在设计及使用FRP-钢胶接节点时,应该充分考虑湿热老化对FRP-钢胶接节点力学性能的影响,避免其发生结构破坏。
关键词:  胶接节点  湿热老化  极限破坏荷载  破坏模式  刚度
DOI:10.11918/202304069
分类号:U448.38
文献标识码:A
基金项目:国家自然科学基金(52278207);广东省重点领域研发计划(2019B111106002);上海市自然科学基金(21ZR1466100);中央高校基本业务费(22120210574)
Mechanical behavior of FRP-steel adhesively-bonded joints under hygrothermal ageing
Xu JIANG, Hao QI, Xuhong QIANG, Kai SUN
College of Civil Engineering, Tongji University, Shanghai 200092, China
Abstract:
In order to further investigate the effects of hygrothermal ageing on the mechanical behavior of fiber reinforced polymer (FRP)-steel adhesively-bonded joints, based on existing studies, a series of loading tests were carried out on the hygrothermal ageing-treated FRP-steel adhesively-bonded joints by using a roulette wheel loading device, respectively, from six loading conditions, to study the effects of hygrothermal ageing on the ultimate failure loads, failure modes, stiffness and strength failure criteria of the FRP-steel adhesively-bonded joints, comparing results with the unaged adhesively-bonded joints. The results show that hygrothermal ageing significantly reduces the ultimate failure loads of the FRP-steel adhesively-bonded joints to 11.0 kN and 41.9 kN under shear and tensile loading, respectively. Under combined loading, the effect of hygrothermal aging on the ultimate failure loads was less pronounced. The strength failure criteria curves of the aged and unaged FRP-steel adhesively-bonded joints are close to each other. For tensile and tensile/shear combined loading conditions, hygrothermal aging altered the failure modes of FRP-steel adhesively-bonded joints, transitioning from partial interfacial failure between the FRP core plate and the structural adhesive layer to a combination of FRP delamination failure covering the entire structural adhesive bonding area and fiber fracture failure. Hygrothermal ageing significantly reduced the stiffness of the FRP-steel adhesively-bonded joints under all six loading conditions. Therefore, the effects of hygrothermal ageing on the mechanical behavior of FRP-steel adhesively-bonded joints should be fully considered when designing and using FRP-steel adhesively-bonded joints to avoid their structural damage.
Key words:  adhesively-bonded joints  hygrothermal ageing  ultimate failure loads  failure modes  stiffness

友情链接LINKS