Abstract:High-strength bolted connections are widely used in various engineering structures, and connection loosening caused by the attenuation of bolt tightening force may pose a serious threat to structural safety. Pressure washers are commonly used sensors for monitoring bolt tightening force. However, for high-strength bolts subjected to large loads, traditional pressure washers have drawbacks such as large sensor size and measurement accuracy that is easily affected by factors including load eccentricity and friction between the sensor and the structural surface, making it difficult to meet the requirements of engineering applications. To address this issue, this paper proposed a smart washer sensor with a novel sensitivity-enhanced structure for monitoring the tightening force of high-strength bolts. Different from traditional pressure washers using a single ring-shaped structure, the proposed smart washer consists of three layers of stacked ring-shaped structures, and the contact surfaces between the middle measuring unit and the upper/lower force transmission units are inwardly tilted annular surfaces. This original sensitivity-enhanced structure converts the vertical bolt pressure on the smart washer into horizontal circumferential expansion deformation of the middle measuring unit, which not only significantly increases the measurement sensitivity of the smart washer but also eliminates the adverse effects of friction between the smart washer and the structural contact surface on measurement accuracy. Through theoretical analysis and numerical simulation, the influence rules of the design parameters of the smart washer on its key measurement indicators such as sensitivity and measurement range were investigated, and a segmented measurement model for the entire loading and unloading processes of the smart washer was proposed. This model solved the problem of inconsistent measurement results during the loading and unloading processes of the smart washer caused by friction between the tilted contact surfaces and further improved the measurement accuracy. Finally, a smart washer sensor with a measurement range of 700 kN was fabricated and tested. The experimental results indicate that the average measurement error of the sensor is only 3 kN. The proposed smart washer sensor has the advantages of small volume, large measurement range, and high accuracy, which has broad engineering application prospects.