Abstract:This paper investigates the wind speed characteristics of bridges located in complex mountainous terrain. Wind tunnel tests were conducted using a terrain model of the bridge site, created based on a 5 km diameter area and scaled at 1∶1 000. A three-dimensional pulsating anemometer was employed to collect and analyze wind speed data at various heights under different wind directions. The study found that when wind flows from the trumpet-shaped estuary, wind speed at the bridge site is relatively high, and wind characteristics along the bridge alignment are well correlated. Turbulent flow fields can mitigate terrain-induced acceleration and shielding effects. Uniform flow fields exhibit higher topographic correction coefficients during river inflow, whereas the opposite is observed in mountainous regions. At varying wind direction angles, significant fluctuations occur at mid-span measurement points in both uniform and turbulent flow fields, making it difficult to describe them using a single model. The variation trend of the wind profile index under different flow conditions aligns with that of the wind direction angle. A top-down approach was adopted to calculate wind speed on the bridge deck in the canyon area. A constrained least squares method was proposed to fit the wind profile index at the vertices of the constrained section in the canyon area. The determination coefficient of the constrained least squares method was found to be similar to that of the traditional least squares method, validating the fitting results. It is proposed to use the index derived from low-height data fitting to calculate the design reference wind speed for the bridge deck in canyon areas. Comparative analysis shows that this method enhances the accuracy of design reference wind speed estimation and facilitates wind speed analysis at the bridge site across various wind directions using a unified index model.