Abstract:In order to test and analyze the mode Ⅰ inter-layer fracture toughness of 3D printing carbon fiber reinforced polymer (CFRP), and quantitatively evaluate the influence of printing parameters on the mode Ⅰ fracture toughness, then promote the application of 3D printing CFRP technology in bridge engineering, experimental and simulation methods were used to carry out the relevant explorations, during this study. Firstly, a novel method for preparing inter-layer pre-cracks of 3D printing CFRP was proposed, namely fracture layer replacement method. Systematic experimental research was conducted by this method, and the influence of two types of key printing parameters on the mode Ⅰ inter-layer fracture toughness was analyzed. Secondly, based on the cohesive zone theory and the surface-based cohesive relationship, simulation models of the double cantilever beam (DCB) test specimens with pre-cracks under various printing conditions were established. Meanwhile, a comparative analysis between simulation and experiment was carried out. The results indicate that the mode Ⅰ inter-layer fracture toughness of 3D printing CFRP increases with the increase of printing temperature and printing speed, and the effect of printing temperature is more significant. When the temperature increases from 245 ℃ to 285 ℃, the fracture toughness increases by 294.6%. When the printing speed increases from 20 mm/s to 60 mm/s, the fracture toughness increases by 27.6%. When the printing temperature and speed are increased, the heat loss of specimen in the printing process is smaller, and the mode Ⅰ inter-layer mechanical properties are improved. However, excessive printing speed can hinder complete deposition and optimal bonding, resulting in negative effects on the mode Ⅰ inter-layer mechanical properties. Moreover, the relative errors between simulation results and experimental data are controlled within 15%, which indicates that the fracture replacement method proposed in this study is reasonable and stable in terms of obtaining test data of type Ⅰ inter-layer fracture toughness. Therefore, this method can provide experimental technical support for the subsequent quantitative evaluation of inter-layer mechanical properties of 3D printing CFRP bridge engineering components.