直流复合绝缘子电场和覆冰相互影响机制分析
CSTR:
作者:
作者单位:

(1.重庆交通大学 机电与车辆工程学院,重庆 400074; 2.输配电装备及系统安全与新技术国家重点实验室(重庆大学),重庆 400044)

作者简介:

韩兴波(1992—),男,副教授,硕士生导师;蒋兴良(1961—),男,教授,博士生导师

通讯作者:

陈孜铭,631476873@qq.com

中图分类号:

TM85

基金项目:

国家自然科学基金(52307161);重庆市教育委员会科学技术研究计划项目(KJQN202000727)


Analysis of interaction mechanism between electric field and ice coating of DC composite insulator
Author:
Affiliation:

(1.School of Mechatronics and Vehicle Engineering, Chongqing Jiaotong University, Chongqing 400074, China; 2.State Key Laboratory of Transmission and Distribution Equipment and System Safety and New Technology (Chongqing University), Chongqing 400044, China)

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    为保障电网及输电线路的安全运行,研究复合绝缘子覆冰规律,提出了耦合场下的复合绝缘子覆冰模型。以FXBW-35/70复合绝缘子为试品,通过建立电场与气流场耦合下的水滴运动控制方程,分析水滴碰撞复合绝缘子在不同位置时所受的电场力分布,探讨风速和水滴粒径对局部碰撞系数 α1和水滴受电场偏移程度Δs的影响,计算并分析不同冰棱分布下复合绝缘子表面整体碰撞系数β1。 最后,开展复合绝缘子干湿增长试验,验证所提模型的有效性。结果表明:伞裙边缘、表面、芯棒处的电场强度依次减弱;带电水滴与不带电水滴均在驻点处α1最大,并随两侧逐渐减小,增大风速或水滴粒径均能提升两者的α1;带电水滴相比不带电水滴在直流电场吸引作用下α1更高,其受电场偏移程度由高压端至低压端逐渐降低,最高偏移率可达30%;降低风速、减小水滴粒径或增大冰棱长度、增加冰棱数量均会降低β1;干增长条件下,覆冰形态在无电场作用下整齐规则,而在带电条件下覆冰速率加快,形态杂乱;湿增长条件下,水滴捕获形成水膜流动并促进冰棱生长,无电场作用下覆冰速率明显降低,带电条件下冰棱出现弯曲且形状不规则。研究成果为明确带电条件下复合绝缘子覆冰生长机制及数值模拟提供技术参考。

    Abstract:

    To investigate the icing mechanism of composite insulators and ensure the safety of power grids and transmission lines, a coupled-field numerical model for composite insulator icing was proposed. Using the FXBW-35/70 composite insulator as the test specimen, the motion control equation of water droplets under the interaction of airflow and electric fields was established. The electric force distribution acting on droplets at different locations of the insulator surface was analyzed. The Influence of wind speed and droplet diameter on the local collision coefficient (α1) and the droplet deflection(Δs) under a DC electric field was examined. Furthermore, the overall collision coefficient (β1) of the insulator surface under different icicle distributions was calculated and analyzed. Finally, dry and wet icing growth experiments were conducted to verify the numerical results. The results show that the electric field strength decreases successively from insulator shed edge to the insulator surface and rod. For both charged and uncharged droplets, α1 reaches its maximum at the stagnation point and decreases gradually toward both sides. Increasing wind speed or droplet diameter enhances α1 for both droplet types. Charged droplets experience stronger electric field attraction, leading to a higher α1 than uncharged droplets, and the deflection due to the electric field gradually decreases from the high-voltage to the grounded end, with a maximum deflection of up to 30%. Reducing wind speed or droplet diameter, or increasing the length or number of icicles, significantly decreases β1. Under dry growth conditions, the icing morphology is more regular without an electric field, whereas under a DC electric field, the icing rate increases and the morphology becomes irregular. Under wet growth conditions, water droplets coalesce into a film, promoting icicles growth. Without an electric field, the icing rate decreases markedly, while under a DC field, icicles become curved and distorted. This study provides a technical reference for understanding the icing mechanism of composite insulators under electric fields and for developing accurate numerical simulation methods.

    参考文献
    相似文献
    引证文献
引用本文

韩兴波,陈孜铭,袁路强,蒋兴良.直流复合绝缘子电场和覆冰相互影响机制分析[J].哈尔滨工业大学学报,2026,58(9):83. DOI:10.11918/202411087

复制
分享
相关视频

文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2024-11-28
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2026-10-11
  • 出版日期:
文章二维码